6029 is owned by the Australian Railway Historical Society, ACT Division and the restoration is proudly supported by their tourist operations and by the generous donations of members and public supporters.
The society operates rail tours out of Canberra with our heritage fleet of steam and diesel locomotives and rolling stock every few weeks.
To travel in style on any of our tours, or to learn more about our collection and operations, go to Canberrarailwaymuseum.org

Jun 18, 2012

Sunday 17 June 2012

The installation of the coupling and connecting rods continued on the right hand leading engine unit. These components were originally crack tested and assessed a few years back and while in storage, had developed the usual layer of surface rust. This was easily was polished off while the locking split pins were fitted to the castellated lock nuts on the coupling rods before the team turned its attention the largest component being the connecting rod. This is a one piece forging that is over ten feet long. The roller bearing was given one last clean out and inspection, then after an initial team meeting (how are we going to do this), the rod was fitted into place. As the rod is very heavy, and we are undercover and without any form of crane, a system of rollers and levers were deployed. To the teams amazement, this task was completed with relative ease. It seems that Mr. Isaac Newton actually did know a thing or two, and not sleeping through the all those physics lectures many years ago actually paid off. Thanks to David, Tony and Patrick for the elbow grease used to polishing the rods. Only three sets to go boys!

Back over in the cab, Andy continued with the fitting of the timber roof lining. This job has to be completed before the electrical conduits can be fully fitted, but more importantly, completion will allow the fitting of the whistle cords. Andy has been working on this job between workdays and estimates that it will be completed in the next month.

Ian and his team have also been working in the cab area, but in this case it’s all under the floor. The myriad of pipes and valves that control the stoker motor continue to be fitted, all be it with continued reference to the original drawings. Ian has copied the pipe drawing and used colored pencils to sort out what goes where.

The front tank is almost ready for the vital water test with only a blanking plate to be fitted in place . This job will have to be done in the mid-afternoon the allow ice to thaw... It is, after all, the middle of winter here.

Alan Gardner